Please note that this is a beta version. We suggest to test it before using it in production. To use the features you need to install the latest Android/iOS beta of the Tentacle Setup App!
Click here to join our beta program
New features:
- TC output via headphone jack
- Send notifications to your phone about critical battery states, recording errors and low remaining recording time
- Fixed a bug where the device could not start recording after jam synced via external LTC
Download:
TRACK E firmware 2.3.0 beta 2 update app (macOS/Windows)
Before you start:
- Before performing the update, please backup your microSD card first
- Make sure your TRACK E has sufficient battery. If your updating computer is a laptop, make sure it has sufficient battery or is connected to mains
- The Tentacle Sync Studio software (macOS) or the Tentacle Setup software (macOS/Windows) should not be running at the same time as the Firmware Update App. The TRACK E can only be detected by one Tentacle software at a time
Update procedure:
- Download the firmware update app, install it and open it
- Connect your TRACK E via USB cable to the computer and switch it on
- Wait for the update app to connect to your TRACK E
- If an update is needed, start the update by pressing the "Start Firmware Update" button
- During the update process (few minutes) your TRACK E status and level LEDs will blink purple
- The updater app will tell you when your TRACK E was successfully updated
- To update more TRACK Es you have to close and start the app again
Note:
In the unlikely case that the firmware update fails, your device needs to be restored. In this case please contact: support@tentaclesync.com