New features:
- TC output via headphone jack
- Send notifications to your phone about critical battery states, recording errors and low remaining recording time
Bug Fixes:
- Fixed a bug where the device could not start recording after jam synced via external LTC
- Fixed a bug where the device was not visible via bluetooth when a zero-length name was set.
- Fixed a bug where the headphone output remained de-activated when the device was sent to sleep and waked up again
- Fixed a bug where the device did not wake up from sleep mode (bug introduced in 2.4.0)
Download:
TRACK E firmware 2.4.1 update app (macOS/Windows)
Before you start:
- Before performing the update, please backup your microSD card first
- Make sure your TRACK E has sufficient battery. If your updating computer is a laptop, make sure it has sufficient battery or is connected to mains
- The Tentacle Sync Studio software (macOS) or the Tentacle Setup software (macOS/Windows) should not be running at the same time as the Firmware Update App.
Update procedure:
- Download the firmware update app, install it and open it
- Connect your TRACK E via USB cable to the computer and switch it on
- Wait for the update app to connect to your TRACK E
- If an update is needed, start the update by pressing the "Start Firmware Update" button
- During the update process (few minutes) your TRACK E status and level LEDs will blink purple
- The updater app will tell you when your TRACK E was successfully updated
- To update more TRACK Es you have to close and start the app again
Note:
Make sure you have the latest iOS/Android Setup App installed.
In the unlikely case that the firmware update fails, your device needs to be restored.
In this case please contact: support@tentaclesync.com